Planter issues.

[craig82c (OP)]

I recently came to notice that when a hire hand is planting the planter does not seed all the way to the actually end point of the planter.  Is there some way in GE or xml that you can adjust the width of seed put down?  It just appears it is not using the full length of the seeder if that makes sense?

[tessfarms]

open the planter in GE and move the start and width out to the ends.

[craig82c (OP)]

open the planter in GE and move the start and width out to the ends.

Thank you tessfarms!  I figured it was something that simple but was not sure if that was it. 
Post Merge: August 18, 2014, 07:57:02 PMI can't for the life of me on the Kinze 3800 find the start and end.

[tessfarms]

Thank you tessfarms!  I figured it was something that simple but was not sure if that was it. 
Post Merge: August 18, 2014, 07:57:02 PMI can't for the life of me on the Kinze 3800 find the start and end.

Expand the first mesh.  They are indexes 0>18 and 0>20

[craig82c (OP)]

That is what I was thinking and what I adjusted.   Again thank you for that!